usb disaster-recovery
Enables the disaster-recovery access to the USB device connected to the USB port when the switch is
unable to boot properly.
usb disaster-recovery {enable | disable}
Syntax Definitions
N/A
Defaults
parameter
enable | disable
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
•
The USB device must contain the proper file structure and image files mentioned below.
•
If miniboot is unable to load AOS from the os.img file then the disaster-recovery operation will begin.
The disaster recovery operation will format the switch flash, copy all of the files from the /uflash/6850/
certified, /uflash/6855/certified, /uflash/6400/certified, or /uflash/9000E/certified directory, based upon
the platform performing the operation, to the /flash/certified directory and reboot the switch.
•
Disaster recovery should be run on a standalone unit so that it does not affect any other units in a stack.
•
A minimum 6.4.3 version of uboot/miniboot is required.
Examples
-> usb disaster-recovery enable
-> usb disaster-recovery disable
Release History
Release 6.4.3; command was introduced.
Related Commands
usb
MIB Objects
systemServices
systemServicesUsbDisasterRecoveryEnable
page 53-30
default
enable
Enables access to the device connected to the USB interface.
OmniSwitch CLI Reference Guide
CMM Commands
June 2012