Show Service Sdp - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

show service sdp

Displays the Service Distribution Point (SDP) configuration for the switch.
show service sdp [sdp-id] [detail]
Syntax Definitions
sdp-id
detail
Defaults
By default, a list of all SDPs is displayed.
Platforms Supported
OmniSwitch 9000E
Usage Guidelines
•
Use the sdp-id parameter to display information for a specific SDP.
•
Use the detail parameter to display additional information about the SDPs.
Examples
-> show service sdp
Services: Service Destination Points
SdpId Adm MTU
--------+---------+---------+----------------+----+-----------+-------+--------
12 0
22 0
32 0
111 0
Number of SDPs : 4
-> show service sdp 32
Services: Service Destination Points
SdpId Adm MTU
--------+---------+---------+----------------+----+-----------+-------+--------
32 0
page 50-80
An existing SDP ID number.
Displays detailed SDP information.
Opr MTU IP address
1514 1.1.1.3
1514 1.1.1.4
1514 1.1.1.5
1514 1.1.1.1
Opr MTU IP address
1514 1.1.1.5
Virtual Private LAN Service (VPLS) Commands
Adm Opr Deliver Signal
Up Up LDP
Up Up LDP
Up Up LDP
Up Up LDP
Adm Opr Deliver Signal
Up Up LDP
OmniSwitch CLI Reference Guide
TLDP
TLDP
TLDP
TLDP
TLDP
June 2012