Ethernet-Service - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

ethernet-service

Creates a VLAN Stacking VLAN (SVLAN) for tunneling customer traffic, a management SVLAN for
provider traffic, or an SVLAN that the IP Multicast VLAN (IPMV) application will use to distribute
multicast traffic.
ethernet-service {svlan | ipmvlan | management-vlan} svid1[-svid2] [enable | disable] [[1x1 | flat] stp
{enable | disable}] [name description]
no ethernet-service {svlan | ipmvlan | management-vlan} svid1[-svid2]
Syntax Definitions
svlan
ipmvlan
management-vlan
svid1
-svid2
enable
disable
1x1
flat
stp enable
stp disable
description
Defaults
By default, the Spanning Tree status is enabled in both the 1x1 and flat mode when the SVLAN or IPMV
is created
parameter
enable | disable
stp enable | disable
description
page 44-2
Creates an SVLAN for tunneling customer traffic.
Creates an SVLAN used by IPMV to distribute multicast traffic.
Creates a management SVLAN for provider traffic.
The VLAN ID number identifying the SVLAN (2–4094).
The last VLAN ID number in a range of SVLANs that you want to
configure (e.g. 10-12 specifies VLANs 10, 11, and 12).
Enables the SVLAN administrative status.
Disables the SVLAN administrative status, which blocks all ports bound
to that SVLAN.
Specifies that the Spanning Tree status for the SVLAN applies when the
switch is running in the 1x1 Spanning Tree mode.
Specifies that the Spanning Tree status for the SVLAN applies when the
switch is running in the flat Spanning Tree mode.
Enables the SVLAN Spanning Tree status for the service provider
network topology.
Disables the SVLAN Spanning Tree status for the service provider
network topology.
An alphanumeric string of up to 32 characters. Use quotes around the
string if the VLAN name contains multiple words with spaces between
them (e.g., "Alcatel-Lucent Engineering").
default
enable
enable
VLAN ID number
VLAN Stacking Commands
OmniSwitch CLI Reference Guide June 2012