AAA Commands
Defaults
parameter
retries
seconds
auth_port
acct_port
Platforms Supported
OmniSwitch 6400, 6850,6850E, 6855, 9000E
OmniSwitch 9000E, 6855-U24X; vrf-name parameter supported.
Usage Guidelines
•
A host name (or IP address) and a secret are required when configuring a server.
•
The server and the backup server must both be RADIUS servers.
•
Configuring multiple RADIUS servers is possible, but all RADIUS servers must belong to the same
VRF instance.
•
If the vrf-name parameter is not specified, the default VRF instance is assigned.
•
Use the no form of the command to remove a RADIUS server from the configuration. Only one server
may be removed at a time. Note that if any Authenticated Switch Access (such as telnet) is configured
for the server, remove the switch access configuration first before attempting to remove the server.
•
To move the RADIUS servers to a different VRF instance, first remove each server from the current
VRF instance and then add each server to the new VRF instance.
Examples
-> aaa radius-server pubs2 host 10.10.2.1 key wwwtoe timeout 5 vrf-name
Management-vrf
-> no aaa radius-server pubs2
Release History
Release 6.1; command was introduced.
Release 6.4.2; vrf-name parameter introduced.
OmniSwitch CLI Reference Guide
default
3
2
1812
1813
June 2012
page 36-5