CMM Commands
show reload
Shows the status of any time delayed reboot(s) that are pending on the switch.
show reload [status]
Syntax Definitions
N/A
Defaults
N/A
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
•
It is possible to preset a reboot on a CMM by using the reload command. If this is done, use the show
reload command to see when the next scheduled reboot will occur.
•
If the reload working command was used, and a rollback timeout was set, the time the rollback will
occur is shown using the show reload command.
•
This command can also be used on the secondary CMM.
Examples
-> show reload status
Primary
Control Module Reload Status: No Reboot Scheduled,
Secondary Control Module Reload Status: No Reboot Scheduled
Release History
Release 6.1; command was introduced.
Related Commands
reload
reload working
OmniSwitch CLI Reference Guide
Reboots the primary or secondary CMM to its startup software configura-
tion.
Immediate primary CMM reboot to the working software configuration
without secondary CMM takeover.
June 2012
page 53-21