Ethernet-Service Svlan Nni - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

ethernet-service svlan nni

Configures the switch port as a VLAN Stacking Network Network Interface (NNI) port and associates the
port with a customer SVLAN or management SVLAN. A network port connects to another provider
bridge and carries both customer and provider traffic.
ethernet-service svlan svid1[-svid2] nni {slot/port1[-port2] | linkagg agg_num} [stp | erp]
no ethernet-service svlan svid1[-svid2] nni {slot/port1[-port2] | linkagg agg_num}
Syntax Definitions
svid1
-svid2
slot/port1
-port2
agg_num
stp
erp
Defaults
parameter
stp | erp
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
•
Use the no form of this command to remove an association between an NNI port and an SVLAN. Note
that when the last SVLAN association is removed, the NNI port reverts to a conventional switch port.
•
This SVLAN ID specified with this command must already exist in the switch configuration. Only
SVLAN IDs are accepted; IPMVLAN IDs are not supported with this command.
•
When this command is used, the default VLAN for the NNI port is changed to a VLAN reserved by the
switch.for applications such as VLAN Stacking. The reserved VLAN is not configurable using stan-
dard VLAN management commands.
•
Associating a network port to an SVLAN is required.
page 44-8
The VLAN ID number identifying the SVLAN (2–4094).
The last VLAN ID number in a range of SVLANs that you want to
specify (e.g. 10-12 specifies VLANs 10, 11, and 12).
The slot number for the module and the physical port number on that
module (e.g., 3/1 specifies port 1 on slot 3).
The last port number in a range of ports that you want to configure on
the same slot (e.g, 3/1-4 specifies ports 1, 2, 3, and 4 on slot 3).
The link aggregate ID number (0–31).
Specifies Spanning Tree control for the SVLAN-NNI association.
Specifies Ethernet Ring Protection (ERP) control for the SVLAN-NNI
association.
default
stp
VLAN Stacking Commands
OmniSwitch CLI Reference Guide June 2012