Write Memory - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

write memory

Copies the running configuration (RAM) to the working directory.
[configure] write memory
Syntax Definitions
N/A
Defaults
N/A
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
•
This command is used to copy the changes made using the CLI commands from the running
configuration (RAM) to the working directory.
•
This command is only valid if the switch is running from the working directory. Use the
running-directory
Note. On an OmniSwitch set up with redundant CMMs, the saved boot.cfg file will be overwritten if the
takeover command is executed after the write memory command.
Examples
-> configure write memory
-> write memory
Release History
Release 6.1; command was introduced.
Related Commands
copy flash-synchro
MIB Objects
configManager
configWriteMemory
page 53-10
command to check from where the switch is running.
Copies the startup primary flash version of the CMM software to the
startup secondary flash version of the CMM software.
OmniSwitch CLI Reference Guide
CMM Commands
show
June 2012