Show Router Ldp Bindings Vc-Type - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

MPLS LDP Commands

show router ldp bindings vc-type

Displays the LDP bindings for the specified virtual circuit (VC) type.
show router ldp bindings vc-type vc-type [vc-id vc-id [session ip-address [:label-space]]
Syntax Definitions
vc-type
vc-id
ip-address
:label-space
Defaults
By default, LDP bindings for all VC IDs and all sessions for each VC ID are displayed for the specified
VC type.
Platforms Supported
OmniSwitch 9000E
Usage Guidelines
•
Use the vc-id parameter to display the LDP bindings for a specific VC ID number.
•
Use the session parameter to display the LDP bindings for a specific session associated with the speci-
fied VC ID number.
Examples
->show router ldp bindings vc-type ethernet
LDP LSR ID: 10.11.0.6
Legend: U = Label In Use, N = Label Not In Use, W = Label Withdrawn,
S = Status Signaled Up,
R = VPRN Service, V = VPLS Service, W = VPWS Service
TLV = (Type, Length: Value)
LDP Service FEC 128 Bindings
Type VCId
------+----------+----------+------+---------------+-------+-------+-----+-----
V-Eth 100
LDP Service FEC 129 Bindings
AGI
Type
------+----------+----------+------+---------------+-------+-------+-----+-----
OmniSwitch CLI Reference Guide
The virtual circuit type. Valid types are ethernet, vlan, and mirror.
The virtual circuit ID number. The valid range is 1–4294967295.
The LDP router ID (Loopback0 IP address configured for the switch)
for a specific LDP session.
The label space ID number that the router advertises on the LDP inter-
face. This value is appended to the LDP router ID address. The valid
range is 0–65535.
D = Status Signaled Down,
SvcId SDPId Peer
100 10 10.11.0.66
SAII
SvcId SDPId Peer
June 2012
IngLbl EgrLbl LMTU
131068U 131068 1500
TAII
IngLbl EgrLbl LMTU
RMTU
1500
RMTU
page 48-49