Show Efm-Oam Port L1-Ping Detail - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

show efm-oam port l1-ping detail

Displays the frames lost during a loopback session.
show efm-oam port slot/port l1-ping detail
Syntax Definitions
slot/port
Defaults
N/A.
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855.
Usage Guidelines
The command can also be used even on a port on which LINK OAM is not enabled.
Examples
-> show efm-oam port 1/1 l1-ping detail
frames configured
frames delay(msec)
L1 ping status
frames sent
frames received
avg delay (msec)
-> show efm-oam port 1/4 l1-ping detail
frames configured
frames delay(msec)
L1 ping status
frames sent
frames received
avg delay (msec)
Output fields are described here:
output definitions
frames configured
delay configured
L1 ping status
frames sent
frames received
average delay
page 46-42
Specifies the slot number for the module and the physical port number
on that module (e.g. 3/1 specifies port 1 on slot 3).
= 5,
= 100,
= Sucessful,
= 4,
= 4,
= 5
= 5,
= 200,
= Successful,
= 4,
= 2,
= 15
Specifies the number of frames that are sent during l1-ping.
Specifies the delay between transmission of two consecutive frames
during L1 ping.
The status of the L1 ping operation. The status can be Successful,
Unsuccessful or default.
Specifies the frames sent during last L1 ping.
Specifies the frames received during last L1 ping.
Specifies the average delay taken by frames during last L1 ping.
LINK OAM Commands
OmniSwitch CLI Reference Guide June 2012