Virtual Private LAN Service (VPLS) Commands
configure service customer create
Creates a customer ID that is used to associate account information with a specific customer. The
customer ID is associated with a Virtual Private LAN Service (VPLS) that is used to carry traffic between
customer sites over a provider-managed MPLS network.
configure service customer customer-id create
configure service no customer customer-id
Syntax Definitions
customer-id
Defaults
A default customer account ID (customer 1) exists on each router and is automatically assigned to new
services.
Platforms Supported
OmniSwitch 9000E
Usage Guidelines
•
Specify a customer ID that does not already exist in the router configuration.
•
Use the no form of this command to remove a customer ID and all associated customer information.
Note that deleting all service associations with a customer ID is required before the ID is removed
from the router configuration.
•
Editing or removing the default customer 1 account is not allowed.
Examples
-> configure service customer 10 create
-> configure service no customer 10
Release History
Release 6.4.2; command was introduced.
OmniSwitch CLI Reference Guide
A unique numerical value to associate with a specific customer. The
valid ID range is 2–2147483647.
June 2012
page 50-3