Configure Router Mpls Interface Label-Map Shutdown - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

configure router mpls interface label-map shutdown

Configures the administrative status for an incoming label-map on a transit Label Switch Router (LSR) or
on an egress Label Edge Router (LER).
configure router mpls interface ip-intf-name label-map in-label {no shutdown | shutdown}
Syntax Definitions
ip-intf-name
in-label
no shutdown
shutdown
Defaults
By default, the incoming label-map is disabled at the time the label-map is created.
Platforms Supported
OmniSwitch 9000E
Usage Guidelines
•
The MPLS interface and incoming label-map number specified with this command must already exist
in the router configuration.
•
Disabling the administrative status of the label-map does not remove the label-map configuration from
the router.
•
When the label-map is disabled, any packets ingressing on the router that contain the label-map number
are dropped.
Examples
-> configure router mpls interface vlan-20 label-map 700 shutdown
-> configure router mpls interface vlan-20 label-map 700 no shutdown
Release History
Release 6.4.2; command was introduced.
page 49-12
The name of an existing MPLS IP interface.
Incoming label-map number. The valid range is 32–1023.
Enables the administrative status of the specified label-map.
Disables the administrative status of the specified label-map.
MPLS Static LSP and FRR Commands
OmniSwitch CLI Reference Guide June 2012