Show Stack Topology - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

show stack topology

Displays the current operating topology of switches within a stack.
show stack topology [slot-number]
Syntax Definitions
slot-number
Defaults
N/A
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855
Usage Guidelines
•
The OS6850E must be in the correct mode depending on which model it is being stacked with.
Examples
-> show stack topology
NI Role
----+-----------+--------+------+-------+-------+-------+-------+-------+-------
1 PRIMARY
2 IDLE
3 SECONDARY
output definitions
NI
Role
page 54-54
Optional syntax specifying a single slot number within the stack (1–8).
When a slot number is specified, topology information for only the
corresponding slot displays.
State Saved Link A
Slot State
RUNNING 1 UP
RUNNING 2 UP
RUNNING 3 UP
The current slot position for each switch in the virtual chassis (i.e.,
stacked configuration). Note that the order of the slot numbers does not
necessarily correspond with the physical positions of switches within
the stack. In other words, slot position 1 may not be the uppermost (top)
switch in the stack. To manually assign these slot numbers via the CLI,
use the stack set slot
The current management role of the corresponding switch within the
stack. Options include PRIMARY (the switch is the primary manage-
ment module in the stack; standalone switches also display this role),
SECONDARY (the switch is the secondary—or backup—management
module in the stack), IDLE (the switch does not have a management
role but is operating normally as a network interface module within the
stack), PASS-THRU (the switch is operating in pass-through mode),
UNDEFINED (the switch's current role is not known).
Chassis Management and Monitoring Commands
Link A Link A
Remote Remote Link B
NI Port State
3 StackB UP
1 StackB UP
2 StackB UP
command.
OmniSwitch CLI Reference Guide
Link B Link B
Remote Remote
NI Port
2 StackA
3 StackA
1 StackA
June 2012