Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual page 3272

Alcatel-lucent omniswitch 6850-48: reference guide
Hide thumbs Also See for OmniSwitch 6850-48:
Table of Contents

Advertisement

output definitions
SDP Id
Type
VC Type
Admin Path MTU
Oper Path MTU
Far End
Delivery
Admin State
Oper State
Collect Stats
Ingress Label
Egress Label
Last Status Change
Signaling
Last Mgmt Change
Flags
Release History
Release 6.4.2; command was introduced.
page 50-98
The SDP identifier comprised of the SDP ID number, the service ID
number, and the IP address of the far-end router for this SDP tunnel.
For example, 10:100 -(10.11.0.6) identifies SDP 10 bound to VPLS
100 with the tunnel endpoint at router 10.11.0.6.
The SDP binding type (mesh or spoke) for this service. The spoke
binding type is not supported. Configured through the
vice vpls mesh-sdp
command.
The type of VC (Ether, Vlan, or Vpls). Configured through the
configure service vpls mesh-sdp
The desired largest frame size that can pass through this SDP to the far-
end router without requiring fragmentation. Configured through the
configure service sdp path-mtu
The actual largest frame size that can pass through this SDP to the far-
end router without requiring fragmentation.
The IP address of the remote end of the MPLS tunnel defined by this
SDP. Configured through the
mand.
Specifies the type of delivery used by this SDP. In this case, LDP-based
MPLS is the supported delivery method; GRE is not supported.
The administrative state of this SDP (Up or Down). Configured
through the
configure service sdp shutdown
The operational state of this SDP (Up or Down).
Specifies whether or not LDP statistics are collected for this SDP.
The VC label used by the far-end device to send packets to the local
device for this SDP binding.
The VC label used by the local device to send packets to the far-end
device for SDP binding.
The date and time of the last operational status change to this SDP.
The signaling protocol used to obtain the ingress and egress labels from
frames transmitted and received on this SDP.
The date and time of the last management-initiated change to this SDP.
The conditions that affect the operational status of this SDP.
Virtual Private LAN Service (VPLS) Commands
command.
command.
configure service sdp far-end
command.
OmniSwitch CLI Reference Guide
configure ser-
com-
June 2012

Advertisement

Table of Contents
loading

Table of Contents