Show Active Policy Rule Meter-Statistics - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

show active policy rule meter-statistics

Displays Tricolor Marking (TCM) packet color statistics for the policy rule. These statistics are kept for
those rules that consist of a TCM policy action (policy action cir). A counter color mode is specified with
the TCM policy action. The counter color mode determines which counter color statistics are displayed
with this command.
show active policy rule [rule_name] meter-statistics
Syntax Definitions
rule_name
Defaults
By default, statistics are displayed for all rules.
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
•
Use the optional rule_name parameter to display statistics for a specific policy rule.
•
This command displays statistics for applied policy rules that are active (enabled) on the switch. Use
the show policy rule
•
Applied rules may or may not be active on the switch. Applied rules are inactive if they have been
administratively disabled with the disable option in the policy rule command.
•
Statistics are shown only for two out of the five available counter colors. The two counters shown are
determined by the counter color mode configured for the TCM policy action. See the
command for more information.
•
A TCM action specifies the rates and burst sizes used to determine drop precedence for packets to
which the action is applied. Packets are marked a certain color based on whether or not they conform to
the specified rates and burst sizes. The packet color indicates the drop precedence (Green = low drop
precedence, Yellow = high drop precedence, and Red = packet is always dropped).
•
Counter color statistics are shown even if there is no bandwidth management configured for the rule. In
this case, the green counter will display the number of packets that matched the rule and the nongreen
counter is set to zero.
Examples
The following command examples display statistics for the Green and Red counters. These are the two
counters specified by the TCM policy action that is assigned to the "R1" and "R2" policy rules.
-> show active policy rule meter-statistics
Policy: R1, Counter Color Mode: GREEN_RED,
Green :
Red :
Yellow :
page 33-226
The name of the rule for which you want to display information; or a
wildcard sequence of characters for displaying information about rules
with similar names. Use an asterisk (*) to indicate a wildcard character.
command to display inactive as well as active policy rules.
75, Non-Green :
50, Non-Red :
0
0,
0,
OmniSwitch CLI Reference Guide
QoS Policy Commands
policy action cir
June 2012