Show Policy Server - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

show policy server

Displays information about servers from which policies may be downloaded to the switch.
show policy server
Syntax Definitions
N/A
Defaults
N/A
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
This command displays basic information about policy servers. Use the show policy server long
command to display more details about the servers.
Examples
-> show policy server
Server IP Address
------+--------------+-----+---------+--------+--------
1 208.19.33.112 389
2 208.19.33.66
output definitions
Server
IP Address
port
enabled
status
primary
Release History
Release 6.1; command was introduced.
page 34-6
port enabled status
Yes Up
400 No Down
The index number corresponding to the LDAP server.
The IP address of the LDAP server.
The TCP/IP port number used by the switch to connect to the policy
server.
Whether or not the policy server is enabled.
The state of the policy server, Unkn, Up or Down.
Indicates whether the server is the primary server; this server will be
used for the next download of policies; only one server is a primary
server.
Policy Server Commands
primary
X
-
OmniSwitch CLI Reference Guide June 2012