Configure Service L2Profile - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

Virtual Private LAN Service (VPLS) Commands

configure service l2profile

Configures a Layer 2 profile that is applied to an access (customer facing) port. This profile is used to
specify how to process Layer 2 control frames ingressing on the access port.
configure service l2profile profile-name [create] {stp | 802.1x | 802.1ab | 802.3ad | gvrp | mvrp | amap}
{peer | discard | tunnel}
configure service no l2profile profile-name
Syntax Definitions
profile-name
create
stp
802.1x
802.1ab
802.3ad
gvrp
mvrp
amap
peer
discard
tunnel
Defaults
A default Layer 2 profile (def-access-profile) exists with the following default values:
parameter
stp
802.1x
802.1ab
802.3ad
gvrp
mvrp
amap
OmniSwitch CLI Reference Guide
Alphanumeric string of up to 32 characters. Use quotes around string if
the profile name contains multiple words with spaces between them
(e.g., "Alcatel-Lucent Engineering").
Creates the Layer 2 profile if the profile-name specified does not exist
in the switch configuration.
Specifies how to process Spanning Tree BPDU.
Specifies how to process 802.1x control frames.
Specifies how to process 802.1ab control frames.
Specifies how to process 802.3ad control frames.
Specifies how to process GARP VLAN Registration Protocol packets.
Specifies how to process Multiple VLAN Registration Protocol packets.
Specifies how to process Alcatel-Lucent Management Adjacency Proto-
col packets.
Allows the UNI port to participate in the specified protocol.
Discards the specified PDU.
Tunnels the specified PDU across the provider network.
default
tunnel
discard
discard
peer
tunnel
tunnel
discard
June 2012 page 50-51