Show Port-Security - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

Learned Port Security Commands

show port-security

Displays Learned Port Security (LPS) configuration and table entries.
show port-security [slot/port1-port2 | slot/port]
Syntax Definitions
slot/port
-port2
slot
Defaults
By default, all ports with an LPS configuration are displayed.
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
•
Displays ports that have an LPS configuration, even if LPS is disabled on the port.
•
Use the slot/port1-port2 parameter with this command to display the LPS configuration for a specific
port or a range of ports.
•
Use the slot parameter with this command to display the LPS configuration for all the ports on a
specific slot.
•
In addition, MAC addresses that were learned on the LPS port because they fell within the specified
MAC address range, appear as a separate entry in the LPS table with a dynamic MAC type.
•
Dynamic MAC addresses become configured MAC addresses in the LPS table when the switch config-
uration is saved and the switch is rebooted. If the configuration is not saved before the next reboot, all
dynamic MAC addresses are cleared from the LPS table.
•
The MAC Type field is blank if an authorized MAC address range is configured for the LPS port.
OmniSwitch CLI Reference Guide
The slot number for the module and the physical port number on that
module (e.g., 3/1 specifies port 1 on slot 3).
The last port number in a range of ports you want to configure on the
same slot (e.g, 3/1-4 specifies ports 1-4 on slot 3).
Enter the slot number for a module to specify that the command should
include all ports on that module (e.g., 6 specifies all ports on the module
found in slot 6 of the switch chassis).
June 2012 page 40-21