Usb Auto-Copy - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

usb auto-copy

Upgrades the image files from the USB device to the /flash/working directory on the switch immediately
after the USB device is connected.
usb auto-copy {enable | disable}
Syntax Definitions
N/A
Defaults
parameter
enable | disable
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
•
The USB device must contain the proper file structure and image files mentioned below and the USB
root directory must contain a signature file named aossignature. The aossignature file can be a blank
text file transferred to the switch.
•
This operation will enable all of the image files from the /uflash/6850/working, /uflash/6855/working,
/uflash/6400/working or /uflash/9000E/working directory, based upon the platform performing the
operation, to be copied to the /flash/working directory and then reboot the switch.
•
If the auto-copy is successful, the auto-copy feature will be disabled before rebooting the switch and
must be re-enabled by the administrator for the next auto-copy process to execute. This will prevent
running the same auto-copy multiple times.
Examples
-> usb auto-copy enable
-> usb auto-copy disable
Release History
Release 6.4.3; command was introduced.
page 53-28
default
disable
OmniSwitch CLI Reference Guide
CMM Commands
June 2012