Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual page 3263

Virtual Private LAN Service (VPLS) Commands
output definitions
SvcId
Service Type
Customer Id
Last Status Change
Last Mgmt Change
Admin State
Oper State
MTU
Def. Mesh VC Id
SAP Count
SDP Bind Count
Send Flush on Fail
Service Access and Destination
Points
Identifier
Type
AdmMTU
OprMTU
OmniSwitch CLI Reference Guide
The unique service identification number used to identify the service.
Configured through the
The type of service (only VPLS is supported).
The customer account ID number. Configured through the
service customer create
The date and time of the last operational status change to this service.
The date and time of the last management-initiated change to this ser-
vice.
The administrative state of the service (Up or Down). Configured
through the configure service vpls shutdown
The operational state of the service (Up or Down).
The largest frame size that can pass through this service without requir-
ing fragmentation. Configured through the
vice-mtu command.
The default VC ID for the mesh SDP binding for this service. Config-
ured through the configure service vpls def-mesh-vc-id
The number of SAPs associated with this service.
The number of SDPs bound to this service.
Whether or not (Enabled or Disabled) a MAC flush message is sent
when an access port or SAP failure occurs. Configured through the
configure service vpls send-flush-on-failure
The following fields display basic information for each SAP and SDP
associated with this service.
The SAP or SDP identifier:
•
The SAP ID is comprised of the access port number and encapsula-
tion value (0, VLAN ID, or all). For example, sap:1/2:100 identi-
fies a SAP on access port 1/2 using a VLAN ID 100 to map
customer traffic tagged with VLAN 100 to the service associated
with the SAP.
•
The SDP identifier is comprised of the SDP ID number, the service
ID number, and the IP address of the far-end router for this SDP
tunnel. For example, 10:100 -M(10.11.0.6) identifies SDP 10
bound to VPLS 100 with the tunnel endpoint at router 10.11.0.6.
The encapsulation type (null or dot1q) configured for the access port.
This indicates the value of the label used to identify the SAP on the
access port. Configured through the
type command. Note that the encapsulation type does not apply to
SDPs;
The desired largest frame size that can pass through the service or SDP
to the far-end router without requiring fragmentation. Configured
through the configure service vpls service-mtu
sdp path-mtu commands.
The actual largest frame size that can pass through the service or SDP
to the far-end router without requiring fragmentation.
June 2012
configure service vpls create
command.
command.
configure service vpls ser-
command.
configure service port encap-
or
command.
configure
command.
configure service
page 50-89