Avlan Default-Traffic - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

avlan default-traffic

Configures whether or not users are able to traffic in the default VLAN before they are actually authenti-
cated.
avlan default-traffic {enable | disable}
Syntax Definitions
enable
disable
Defaults
parameter
enable | disable
Platforms Supported
OmniSwitch 6400, 6850,6850E, 6855, 9000E
Usage Guidelines
•
When this command is enabled, users are members of the default VLAN before authentication. After
authenticating, users are no longer authorized for the default VLAN.
•
When this command is disabled after being enabled, existing users in the default VLAN are not
flushed.
•
The default VLAN is configurable per port through the
•
The avlan default-traffic command allows Telnet and HTTP clients to obtain an IP address from a
DHCP server in the default VLAN.
Examples
-> avlan default-traffic enable
Release History
Release 6.1; command was introduced.
page 36-42
Enables the switch to allow users authenticating through the switch to
traffic in the default VLAN prior to authentication.
Disables the switch so that users authenticating through the switch
cannot traffic in the default VLAN prior to authentication.
default
disable
vlan port default command.
OmniSwitch CLI Reference Guide
AAA Commands
June 2012