Configure Router Mpls Static-Lsp Shutdown - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

configure router mpls static-lsp shutdown

Configures the administrative status for the specified static Label Switched Path (LSP).
configure router mpls static-lsp lsp-name {no shutdown | shutdown}
Syntax Definitions
lsp-name
no shutdown
shutdown
Defaults
By default, the static LSP is disabled when the LSP is created.
Platforms Supported
OmniSwitch 9000E
Usage Guidelines
•
The LSP name specified with this command must already exist in the router configuration.
•
Disabling the administrative status of the static LSP does not remove the LSP configuration from the
router, however, packet forwarding to the next-hop router is stopped. When a disabled static LSP is
enabled, packet forarding continues.
Examples
-> configure router mpls static-lsp to-R3 no shutdown
-> configure router mpls static-lsp to-R3 shutdown
Release History
Release 6.4.2; command was introduced.
page 49-16
The name of an existing static LSP.
Enables the administrative status of the specified static LSP.
Disables the administrative status of the specified static LSP.
MPLS Static LSP and FRR Commands
OmniSwitch CLI Reference Guide June 2012