Port Monitoring Source - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

Port Mirroring and Monitoring Commands

port monitoring source

Configures a port monitoring session.
port monitoring port_monitor_sessionid source slot/port
[{no file | file filename [size filesize] | [overwrite {on | off}]}]
[inport | outport | bidirectional] [timeout seconds] [enable | disable]
Syntax Definitions
port_monitor_sessionid
slot/port
file filename
filesize
no file
on
off
inport
outport
seconds
enable
disable
Defaults
parameter
filesize
on | off
bidirectional | inport | outport bidirectional
seconds
enable | disable
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855
OmniSwitch CLI Reference Guide
Monitoring session identifier.
Enter the slot number for the module and the physical port number on
that module (e.g., 3/1 specifies port 1 on slot 3).
Specifies a file name for the monitoring session (e.g., /flash/port2).
Specifies the size of the file in 16K (16384) byte increments. For exam-
ple, a value of 3 would specify a size of 49152 bytes. The file size can
be up to 160 K (163840 bytes).
Specifies that no file will be created for the monitoring session.
Specifies that any existing port monitoring file in flash memory will be
overwritten if the total data exceeds the specified file size.
Specifies that any existing port monitoring file in flash memory will not
be overwritten if the total data exceeds the specified file size.
Specifies incoming unidirectional port monitoring.
Specifies outgoing unidirectional port monitoring.
Specifies the number of seconds after which the session is disabled. The
range is 0–2147483647 where 0 is forever.
Enables the port monitoring status.
Disables the port monitoring status.
default
1
on
0
disable
June 2012 page 41-7