Show Policy Classify Dscp - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

QoS Policy Commands

show policy classify dscp

Specifies a DiffServ Code Point (DSCP) value for a hypothetical packet to show how the QoS software in
the switch will handle the packet.
show policy classify {l2 | l3 | multicast} [applied] dscp dscp_value
Syntax Definitions
l2
l3
multicast
applied
dscp_value
Defaults
N/A
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
•
Use this command to determine if the switch will classify the traffic condition specified and match it to
a policy. By default the classifier only tests pending policies (policies that have not yet been applied).
Use the applied keyword to test only those policies that have been applied.
•
Use the qos apply command to activate policies.
•
If a DSCP value is specified, a ToS value may not be specified.
Examples
-> show policy classify l3 dscp 63
See the output example given on
Release History
Release 6.1; command was introduced.
OmniSwitch CLI Reference Guide
Uses the Layer 2 classifier for the hypothetical packet.
Uses the Layer 3 classifier for the hypothetical packet.
Uses the multicast IGMP classifier for the hypothetical packet.
Indicates that only applied policies should be examined.
The DiffServ Code Point value, in the range 0–63.
page 33-167 for more information about the potential screen display.
June 2012 page 33-195