Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual page 3121

MPLS LDP Commands
output definitions
KA Timeout
Transport Address
Last Modified
Active Adjacencies
Tunneling
Lsp Name
Release History
Release 6.4.2; command was introduced.
Related Commands
show router ldp parameters
show router ldp discovery
interface
show router ldp peer
MIB Objects
vRtrLdpHelloAdjTable
vRtrLdpPeerLdpId
vRtrLdpHelloAdjLocalLdpId
vRtrLdpHelloAdjEntityIndex
vRtrLdpHelloAdjIndex
vRtrLdpHelloAdjHoldTimeRemaining
vRtrLdpHelloAdjType
vRtrLdpHelloAdjRemoteConfSeqNum
vRtrLdpHelloAdjRemoteIpAddress
vRtrLdpHelloAdjUpTime
vRtrLdpHelloAdjLocalConfSeqNum
vRtrLdpHelloAdjLocalIpAddress
vRtrLdpHelloAdjInHelloMsgCount
vRtrLdpHelloAdjOutHelloMsgCount
vRtrLdpHelloAdjLocalHelloTimeout
vRtrLdpHelloAdjRemoteHelloTimeout
OmniSwitch CLI Reference Guide
The amount of time, in seconds, LDP waits to receive keepalive mes-
sages from an LDP peer before tearing down the session with that peer.
Configured through the
keepalive command.
The IP address used to set up an LDP session (System or Interface).
The System value indicates that the Loopback0 address for the switch
is used. The Interface value indicates that the IP address for the inter-
face is used.
The date and time the interface configuration was last modified.
The number of active adjacencies between this interface and LDP
peers.
The tunneling status for the interface (Enabled or Disabled).
The name of the Label Switch Path associated with this interface.
Displays the LDP graceful restart, interface, and targeted session param-
eter values for the local router.
Displays the discovery status of the LDP Hello adjacencies associated
with the specified LDP interface.
Displays configuration information for LDP peers.
June 2012
configure router ldp interface-parameters
page 48-65