Aaa Authentication Vlan Multiple-Mode - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

AAA Commands

aaa authentication vlan multiple-mode

Specifies the AAA servers to be used in multiple-authority mode for Authenticated VLANs.
aaa authentication vlan multiple-mode vlan_id server1 [server2] [server3] [server4]
no aaa authentication vlan vlan_id
Syntax Definitions
vlan_id
server1
server2...server4
Defaults
N/A
Platforms Supported
OmniSwitch 6400, 6850,6850E, 6855, 9000E
Usage Guidelines
•
Use the no form of the command to remove Authenticated VLANs in multiple mode.
•
The servers may be RADIUS, TACACS+, or LDAP servers, or both. Up to 4 servers (total) may be
configured for each VLAN in multiple mode. Each server name should be separated by a space.
•
The switch uses only the first available server in the list to check for user information. For example, if
server1 is not available, the switch will poll server2. If user information is not found on the first avail-
able server, the authentication request will fail.
•
RADIUS, TACACS+, and LDAP servers may each have an additional backup specified through the
aaa radius-server,
Examples
-> aaa authentication vlan multiple-mode 2 pubs1 pubs2
Release History
Release 6.1; command was introduced.
OmniSwitch CLI Reference Guide
The VLAN associated with the server or chain of servers.
The name of the RADIUS, TACACS+, or LDAP authentication server
used for this Authenticated VLAN in multiple mode. At least one server
is required. RADIUS, TACACS+, and LDAP server names are set up
through the aaa
aaa ldap-server
The names of backup servers for authenticating users through this
VLAN. Up to 3 backups may be specified; include a space between
each server name. These backups are only used if server1 becomes
unavailable. They are polled in the order they are listed in this
command. The first available server becomes the authentication server.
aaa tacacs+-server, and
June 2012
radius-server, aaa tacacs+-server, and
commands.
aaa ldap-server commands.
page 36-17