Configure Service Port Encap-Type - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

configure service port encap-type

Configures an encapsulation type for the specified service access port. The encapsulation type determines
if the access port will support single or multiple Service Access Points (SAPs) for customer services.
configure service port {slot/port | linkagg agg_num} encap-type {null | dot1q}
Syntax Definitions
slot/port1
agg_num
null
dot1q
Defaults
By default, the null encapsulation type is selected when the port is configured as a service access port.
Platforms Supported
OmniSwitch 9000E
Usage Guidelines
•
Specify only ports or link aggregates that are configured as service access ports. This command does
not apply to network ports.
•
The encapsulation type configured for the access port determines the encapsulation type for any SAPs
associated with the port.
Examples
-> configure service port 1/3 encap-type null
-> configure service port linkagg 10 encap-type null
-> configure service port 1/17 encap-type dot1q
-> configure service port linkagg 20 encap-type dot1q
Release History
Release 6.4.2; command was introduced.
page 50-58
The slot and port number of the service access port.
The link aggregate ID number (0–31) of a service access link aggregate.
Allows only one SAP (one customer service) on the port. All customer
traffic (tagged and untagged) is allowed.
Allows multiple SAP associations (customer services) for the port. Only
802.1Q-tagged traffic on the port.
Virtual Private LAN Service (VPLS) Commands
OmniSwitch CLI Reference Guide June 2012