Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual page 2444

Examples
-> show active policy rule
Policy
R1
(L2/3):
R2
(L2/3):
R3
(L2/3):
output definitions
Policy
From
Prec
Enab
Act
Refl
Log
Trap
Save
Def
Matches
{L2/3}
page 33-224
From Prec Enab Act Refl Log Trap Save Def Matches
cli 0 Yes Yes
C1 -> QoS_Action1
cli 0 Yes Yes
C2 -> QoS_Action1
cli 0 Yes Yes
C3 -> QoS_Action1
The name of the policy rule, configured through the
mand. A plus sign (+) preceding a policy rule name indicates that the
policy rule has been modified or has been created since the last qos
apply.
Where the rule originated.
The precedence of the rule. Precedence determines the order in which
the switch will apply rules.
Whether or not the rule is administratively enabled. (By default, rules
are enabled.)
Whether or not the rule is enforceable by the switch (e.g., qos is
enabled, rule is valid and enabled, validity period is active).
Whether the rule is reflexive or not.
Whether or not the switch will log messages about specific flows com-
ing into the switch that match this policy rule. Configured through the
policy rule command.
Whether or not traps are enabled for the rule. Configured through the
policy rule command. A trap is sent when a port is administratively
disabled through a port disable action or a UserPort shutdown function
Whether the rule will be captured in an ASCII text file (using the
configuration snapshot
after the write memory command or
or saved after a reboot. Configured through the
Whether or not the rule is a member of the default policy list. Config-
ured through the policy rule
The number of flows matching this rule. Note that for ingress maxi-
mum bandwidth policies, the value in this field indicates the number of
packets that exceed the bandwidth limit, not the packets that match the
rule.
The condition and the action associated with the rule; configured
through the policy condition
tively.
QoS Policy Commands
No No Yes
No No Yes
No No Yes
command), saved to the working directory
reload issu command is entered,
policy rule
command.
and policy action commands respec-
OmniSwitch CLI Reference Guide
Yes Yes 2
Yes Yes 0
Yes Yes 0
policy rule com-
command.
June 2012