Port-Security Max-Filtering - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

port-security max-filtering

Configures the maximum number of MAC addresses that can be filtered on the LPS port(s).
port-security slot/port[-port2] max-filtering num
Syntax Definitions
slot/port
-port2
max-filtering num
Defaults
By default, the maximum number of filtered MAC addresses that can be learned on an LPS port is set to 5.
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
•
When the LPS learning window time expires, MAC addresses are learned in a filtering state up to the
maximum filtering value set with this command. For example, if the maximum filtering value is set to
five, when the learning window time expires, the switch will learn up to five filtering MAC addresses.
•
If an LPS port is in a violation state and the maximum number of filtering MAC addresses allowed is
changed, the port transitions out of the violation state.
•
The maximum filtering value is separate from the maximum bridged MAC address value.
•
When the number of filtered MAC addresses learned on the port reaches the maximum, either the port
is disabled (Shutdown Violation mode) or MAC address learning is disabled (Restrict Violation mode).
By default, MAC address learning is disabled on a port.
Examples
-> port-security 1/10 max-filtering 6
-> port-security 1/10-13 max-filtering 18
Release History
Release 6.1.5; command was introduced.
page 40-8
The slot number for the module and the physical port number on that
module (e.g., 3/1 specifies port 1 on slot 3).
The last port number in a range of ports you want to configure on the
same slot (e.g, 3/1-4 specifies ports 1-4 on slot 3).
The maximum number of filtered MAC addresses (1–100) that are
allowed on this port.
Learned Port Security Commands
OmniSwitch CLI Reference Guide June 2012