Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual page 3018

output definitions (continued)
Mode
Max OamPDU size
Config Revision
Functions Supported
Loopback Status
Loopback Rx Status
Max OamPDUs
KeepAlive Interval
Hello Interval
Dying Gasp Notify Status
Critical Event Notify Status
Link Monitoring
Window
Threshold
Notify Status
Release History
Release 6.4.2; command was introduced.
Related Commands
show efm-oam port
MIB Objects
dot3OamTable
dot3OamAdminState
dot3OamOperStatus
dot3OamMode
dot3OamMaxOamPduSize
dot3OamConfigRevision
dot3OamFunctionsSupported
alaDot3OamTable
alaDot3OamKeepAliveInterval
alaDot3OamHelloInterval
dot3OamLoopbackTable
dot3OamLoopbackStatus
page 46-32
The state of LINK OAM mode on the port, active or passive.
Displays the maximum OAMPDU that the LINK OAM port can sup-
port.
Displays the configuration revision of the LINK OAM port as reflected
in the latest OAMPDU sent by the peer port.
Displays the LINK OAM functions supported by the specified port.
Displays the loopback status of the specified LINK OAM port.
The action that should be performed by the LINK OAM port when a
loopback request is received from the peer port.
Specifies the maximum OAMPDUs that can be exchanged between
two peers.
Displays the timeout interval of the specified LINK OAM port for the
dynamically learned peer port.
Displays the time interval between two OAMPDUs in seconds.
The state of notification for dying gasp events, enable or disable.
The state of notification for critical events, enable or disable.
Displays the errors detected on the remote link.
The frame error event window in the received OAMPDU.
The number of errored frames in the period required for the event to be
generated.
The state of notification for LINK OAM errors on the port, enable or
disable.
Displays the status of LINK OAM on all the ports in the system,
along with other relevant information like OAM mode, operational
status and loopback status of the port.
LINK OAM Commands
OmniSwitch CLI Reference Guide June 2012