Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual page 2944

Usage Guidelines
•
Source and target MEP-ID, MD and MA must already exist before loopback is initiated.
•
If data TLV is not set, then it is not sent in the loopback message.
Examples
-> ethoam loopback target-endpoint 10 source-endpoint 20 domain MD association MA
number 3
Reply from 00:0E:B1:6B:43:89: bytes=64 seq=0 time=100ms
Reply form 00:0E:B1:6B:43:89: bytes=64 seq=0 time=112ms
Request timed out.
----00:E0:B1:6B:43:89 ETH-LB Statistics----
3 packets transmitted, 2 packets received, 33% packet loss
round-trip (ms)
Release History
Release 6.2.1; command was introduced.
Release 6.3.1; target-macaddress, target-endpoint, source-endpoint, and domain mac_address parame-
ters added; end-point parameter deleted.
Related Commands
show ethoam domain
MIB Objects
dot1agCfmMdTable
dot1agCfmMdName
dot1agCfmMaNetTable
dot1agCfmMaNetName
dot1agCfmMepTable
dot1agCfmMepIdentifier
dot1agCfmMepTransmitLbmDestMacAddress
dot1agCfmMepTransmitLbmDestMepId
dot1agCfmMepTransmitLbmDestIsMepId
dot1agCfmMepTransmitLbmMessages
dot1agCfmMepTransmitLbmDataTlv
dot1agCfmMepTransmitLbmVlanPriority
dot1agCfmMepTransmitLbmVlanDropEnable
dot1agCfmMepTransmitLbmStatus
page 45-40
min/avg/max = 100/106/112
Displays the information of a specified Management Domain con-
figured on the bridge.
Ethernet OAM Commands
OmniSwitch CLI Reference Guide June 2012