Configure Router Mpls Shutdown - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

MPLS Static LSP and FRR Commands

configure router mpls shutdown

Configures the administrative status of the MPLS protocol instance.
configure router mpls {no shutdown | shutdown}
Syntax Definitions
no shutdown
shutdown
Defaults
By default, MPLS is enabled for the switch.
Platforms Supported
OmniSwitch 9000E
Usage Guidelines
•
Disabling the MPLS instance disables the Label Switched Paths attached to the instance, as well as any
Service Distribution Points (SDPs) and SDP bindings associated with the LSP. When the MPLS
instance is once again enabled, the attached LSPs will attempt to re-activate.
•
Note that deleting the MPLS instance is not allowed; there is no command for this purpose. Only
changing the administrative status of the instance is allowed.
Examples
-> configure router mpls no shutdown
-> configure router mpls shutdown
Release History
Release 6.4.2; command was introduced.
Related Commands
show router mpls status
MIB Objects
vRtrMplsGeneralTable
vRtrMplsGeneralAdminState
OmniSwitch CLI Reference Guide
Enables the MPLS protocol instance.
Disables the MPLS protocol instance.
Displays the status of the MPLS instance on the router.
June 2012 page 49-3