Clear Service Id Fdb - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

clear service id fdb

Clears MAC addresses (including static) from the Source Learning MAC address Forwarding Database
(FDB) for the specified VPLS service.
clear service id service-id fdb {all | mac mac-address | sap {slot/port | linkagg agg_num} [:0 | :all |
:qtag1] | mesh-sdp sdp-id[:vc-id]}
Syntax Definitions
service-id
all
mac-address
slot/port1
agg_num
:0
:all
:qtag1
sdp-id
vc-id
Defaults
parameter
:0 | :all | :qtag
vc-id
Platforms Supported
OmniSwitch 9000E
page 50-70
An existing VPLS ID number.
Clear all MAC addresses from the FDB for the specified service.
A 48-bit MAC address (aa:bb:cc:dd:ee:ff) to clear from the FDB.
Clears FDB entries related to this address.
The slot and port number of a service access port that identifies the
specified SAP.
The link aggregate ID number (0–31) of a service access link aggre-
gate.that identifies an existing SAP.
The encapsulation type portion of the SAP ID that specifies a null
encapsulation value for the SAP. Depending on the pre-configured
encapsulation type for the access port, a SAP using a null encapsulation
will direct tagged and untagged or only untagged traffic to the associ-
ated service.
The encapsulation type portion of the SAP ID that determines if
untagged and tagged traffic is mapped to the SAP. Combine this param-
eter with the slot/port or linkagg parameters.
The encapsulation type portion of the SAP ID that identifies a VLAN ID
tag for SAP traffic. Combine this parameter with the slot/port or link-
agg parameters.
An existing SDP ID number.
A VC ID number that identifies the VC ID portion of each mesh SDP
binding defined for the service.
default
null
service-id value
Virtual Private LAN Service (VPLS) Commands
OmniSwitch CLI Reference Guide June 2012