Saa Type Ethoam-Loopback - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

saa type ethoam-loopback

Configures the SAA for ETH-LB, including the number of packets and inter-packet delay parameters.
saa string type ethoam-loopback {target-endpoint tmep_id | target-mac address mac} source-endpoint
smep_id domain domain association assoc vlan-priority priority [drop-eligible {true | false}] [data
data] [num-pkts num] [inter-pkt-delay delay]
Syntax Definitions
string
tmep-id
mac
smep-id
domain
assoc
priority
drop-eligible true
drop-eligible false
data
delay
num
Defaults
parameter
drop-eligible true | false
num-pkts
delay
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
•
The SAA must exist before issuing the CLI. If the SAA does not exist, the CLI will return error.
•
Source MEP-ID, MD and MA must be created before initiating loopback.
page 47-6
SAA ID string up to 32 characters. Use quotes around string if SAA ID
contains multiple words with spaces between them (e.g. "SAA 10").
The ID of the destination MEP
The MAC address of the destination.
The ID of the source MEP.
The domain to which the source MEP belongs.
The association to which the source MEP belongs.
The VLAN priority to be used for the outgoing packet.
Valid range is 0 – 7.
Sets the drop enable bit in the VLAN tag of the outgoing packet to true.
Sets the drop enable bit in the VLAN tag of the outgoing packet to false.
User specified string that is included in the packet.
The delay between packets sent during a ping iteration in milliseconds.
Valid range is 100ms - 1000ms in multiples of 100ms.
The number of packets to be sent during loopback. Valid range is 1 - 10.
default
false
5
1000
Service Assurance Agent Commands
OmniSwitch CLI Reference Guide June 2012