Configure Service Vpls Sap Create - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

configure service vpls sap create

Configures a Service Access Point (SAP) by associating a SAP ID with a Virtual Private LAN Service
(VPLS). A SAP ID is comprised of a customer-facing port (referred to as an access port) and an encapsu-
lation value that is used to identify the type of customer traffic to map to the associated service.
configure service vpls service-id sap {slot/port | linkagg agg_num} [:0 | :all | :qtag1] create
configure service vpls service-id no sap {slot/port | linkagg agg_num} [:0 | :all | :qtag1]
Syntax Definitions
service-id
slot/port1
agg_num
:0
:all
:qtag1
Defaults
parameter
:0 | :all | :qtag1
Platforms Supported
OmniSwitch 9000E
Usage Guidelines
•
To specify a SAP ID, use the slot/port and linkagg agg-num parameters combined with the :0, :qtag,
or :all parameters. For example, enter 1/2:all to specify the SAP on access port 1/2 that maps all traffic
to this service that is not already mapped to other SAPs.
•
Use the no form of this command to remove a a SAP.
•
Specify only ports or link aggregates that are configured as service access ports (see
port mode access). This command does not apply to network ports.
•
The encapsulation mode for the access port determines how many SAPs are allowed on the access port.
If the port is set to null encapsulation, only one default SAP is allowed on the port. If the port is set to
page 50-60
An existing VPLS ID number.
The slot and port number of the service access port.
The link aggregate ID number (0–31) of a service access link aggregate.
Specifies a null encapsulation value for the SAP. Depending on the pre-
configured encapsulation type for the access port, a SAP using a null
encapsulation will direct tagged and untagged or only untagged traffic to
the associated service.
Specifies a wildcard SAP. All tagged or untagged traffic that is not clas-
sified into another SAP is mapped to the wildcard SAP. Not config-
urable on null encapsulation access ports.
Specifies a VLAN ID tag for traffic ingressing on the access port. Only
traffic with this tag is mapped to this SAP. Not configurable on null
encapsulation access ports.
default
:0 (null)
Virtual Private LAN Service (VPLS) Commands
OmniSwitch CLI Reference Guide
configure service
June 2012