Show Ethoam Domain Association End-Point - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

show ethoam domain association end-point

Displays the information of a specific MEP in a Management Domain configured on the bridge.
show ethoam domain md_name association ma_name end-point mep-id
Syntax Definitions
md_name
ma_name
mep-id
Defaults
N/A
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
N/A
Examples
-> show ethoam domain MD association MA endpoint 10
Admin State : disable,
Direction : up,
Slot/Port: virtual,
MacAddress: 00:E0:B1:A0:78:A3,
Fault Notification : FNG_RESET,
CCM Enabled : disabled,
RFP Status : enabled,
CCM Linktrace Priority : 7,
CCM Not Received : false,
CCM Error defect : false,
CCM Xcon defect : false,
MEP RDI defect : false,
MEP Last CCM Fault : not specified,
MEP Xcon Last CCM Fault : not specified,
MEP Error Mac Status : false,
MEP Lbm NextSeqNumber : 0,
MEP Ltm NextSeqNumber : 32157,
Fault Alarm Time : 250,
Fault Reset Time : 1000,
Lowest PrDefect Allowed : DEF_MAC_REM_ERR_XCON,
Highest PrDefect Present : DEF_NONE
page 45-56
Specifies the domain name.
Name of the Ethernet OAM Association.
Specifies the MEP of a specific MA. The valid range is 1–8191.
Ethernet OAM Commands
OmniSwitch CLI Reference Guide June 2012