Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual page 2853

VLAN Stacking Commands
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
•
Use the no form of this command to delete an SVLAN or a range of SVLANs. Note that SVLAN port
associations are also removed when the SVLAN is deleted.
•
This command does not work if the svid specified already exists as a standard VLAN.
•
Use the optional 1x1 or flat parameter with this command to configure the Spanning Tree status only
for the Spanning Tree mode specified by the parameter. For example, if the flat parameter is specified
when disabling STP for SVLAN 10, then the Spanning Tree status for SVLAN 10 is disabled when the
switch is running in the flat mode. However, the current Spanning Tree status for SVLAN 10 in the
1x1 mode remains unchanged.
•
If this command is used without specifying the 1x1 or flat parameter, then the Spanning Tree status for
the specified SVLAN is changed for both operating modes.
•
Note that the Spanning Tree status for an SVLAN only applies to the Spanning Tree topology
calculations for the service provider network. This status is not applied to customer VLANs
(CVLANs) and does not affect the customer network topology.
Examples
-> ethernet-service svlan 1001 name "Customer ABC"
-> ethernet-service ipmvvlan 255
-> ethernet-service management-vlan 355
-> no ethernet-service svlan 1001
-> no ethernet-service ipmvlan 255
-> no ethernet-service management-vlan 355
Release History
Release 6.3.1; command was introduced.
Related Commands
show ethernet-service vlan
ethernet-service source-
learning
MIB Objects
vlanTable
vlanNumber
vlanDescription
vlanSvlanTrafficType
vlanAdmStatus
vlan1x1StpStatus
vlanFlatStpStatus
vlanStpStatus
vlanStatus
OmniSwitch CLI Reference Guide
Displays a list of SVLANs configured fro the switch
Configures the source learning status for an SVLAN.
June 2012 page 44-3