Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual page 3257

Virtual Private LAN Service (VPLS) Commands
No Programmed LSPs
output definitions
SDP Id
Admin Path MTU
Oper Path MTU
Far End
Delivery
Admin State
Oper State
Signaling
Collect Stats
Last Status Change
Last Mgmt Change
Flags
Associated LSP List
Programmed LSP List
Release History
Release 6.4.2; command was introduced.
Related Commands
show service sdp-using
show service id sdp
MIB Objects
OmniSwitch CLI Reference Guide
The SDP identifier comprised of the SDP ID number and the IP
address of the far-end router for this SDP tunnel. For example, 10: -
(1.1.1.2) identifies SDP 10 with the tunnel endpoint at router 1.1.1.2.
The desired largest frame size that can pass through this SDP to the far-
end router without requiring fragmentation. Configured through the
configure service sdp path-mtu
The actual largest frame size that can pass through this SDP to the far-
end router without requiring fragmentation.
The IP address of the remote end of the MPLS tunnel defined by this
SDP. Configured through the
mand.
Specifies the type of delivery used by this SDP. In this case, LDP-based
MPLS is the supported delivery method; GRE is not supported.
The administrative state of this SDP (Up or Down). Configured
through the configure service sdp shutdown
The operational state of this SDP (Up or Down).
Indicates whether or not Targeted LDP signaling is enabled (none or
TLDP). Note that if TLDP is not enabled, only static LSPs are config-
urable for this SDP.
Specifies whether or not LDP statistics are collected for this SDP.
The date and time of the last operational status change to this SDP.
The date and time of the last management-initiated change to this SDP.
The conditions that affect the operational status of this SDP.
Displays static LSP information.
Displays LDP-signaled LSP information.
Displays the Service Distribution Point (SDP) usage for the local router
or for a far-end router IP address.
Displays the detailed configuration for the specified service ID, includ-
ing all SDPs and SAPs associated with the service.
June 2012
command.
configure service sdp far-end
command.
com-
page 50-83