Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual page 2785

Learned Port Security Commands
•
Note that even after the learning window time expires, MAC addresses are stilled learned as filtered
addresses up to the configured maximum number of filtered MAC addresses allowed on the LPS port.
•
For example, if the maximum number of MAC addresses allowed is set to 30 and the learning window
expires when the port has only learned 15, the port still allows to learn 15 MAC addresses.
•
If the convert-to-static parameter is enabled and the LPS source learning time window expires, then
all dynamic MAC addresses are converted to static MAC addresses. This stops the MAC addresses
from aging out.
•
The conversion of dynamic MAC addresses to static ones does not apply to LPS mobile and authenti-
cated ports.
Examples
-> port-security shutdown 25
-> port-security shutdown 60 no-aging enable
-> port-security shutdown 2 convert-to-static enable no-aging enable
-> port-security shutdown 2 convert-to-static enable no-aging enable boot-up enable
Release History
Release 6.1; command was introduced.
Release 6.1.5; convert-to-static parameter added.
Release 6.4.4; no-aging and boot-up parameters added.
Related Commands
port-security
port-security mac
port-security mac-range
port-security maximum
port-security violation
MIB Objects
learnedPortSecurityGlobalGroup
lpsLearningWindowTime
lpsLearningWindowTimeWithStaticConversion
lpsLearningWindowNoAging
lpsLearningWindowBootupStatus
OmniSwitch CLI Reference Guide
Enables or disables Learned Port Security (LPS) on the switch port(s).
Configures a single authorized source MAC address for a port that
belongs to a specified VLAN.
Configures a list of authorized MAC addresses by defining a range of
addresses allowed on the port.
Specifies the maximum number of source MAC addresses that an LPS
port(s) is allowed to learn.
Selects the method for handling traffic that does not comply with LPS
restrictions for the specified port.
June 2012 page 40-5