Show Rmon Probes - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

show rmon probes

Displays a list of RMON probes or a single RMON probe.
show rmon probes [stats | history | alarm] [entry-number]
Syntax Definitions
stats
history
alarm
entry-number
Defaults
N/A
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
•
To display a list of current probes, omit the entry-number from the command line.
•
To display statistics for a particular probe, include the probe's entry-number in the command line.
•
The show rmon probes command displays the following information: Entry number, Slot/Port, Flavor
(whether the probe type is Ethernet, History or Alarm), Status (Active or Inactive), Duration (time
since the last change in status, in hours/minutes) and System Resources (the amount of memory allo-
cated to this probe).
•
The show rmon probes entry-number command displays the following information: Probe's Owner
(probe type and location), Slot/Port, Entry number, Flavor (whether the probe type is Ethernet, History
or Alarm), Status (Active or Inactive), Time since the last change in status (hours/minutes), and System
Resources (the amount of memory allocated to this probe). Displayed statistics may vary, depending on
whether the probe type is Ethernet, History or Alarm.
Examples
-> show rmon probes stats
Entry Slot/Port
-------+-----------+-----------+----------+---------------+---------------------
4001 4/1
4008 4/8
4005 4/5
page 43-4
Ethernet Statistics Table probe entries.
History Control Table probe entries.
Alarm Table probe entries.
The entry number in the list of probes (optional).
Flavor Status
Ethernet Active
Ethernet Active
Ethernet Active
Duration System Resources
00:25:00 275 bytes
00:25:00 275 bytes
00:25:00 275 bytes
OmniSwitch CLI Reference Guide
RMON Commands
June 2012