Ethoam Loopback - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

Ethernet OAM Commands

ethoam loopback

Initiates the transmission of loopback messages from the specified source MEP to the specified target
MEP or MAC address. Also triggers the source MEP to detect the presence or lack of a corresponding
loopback reply from the target.
ethoam loopback {target-endpoint t-mepid | target-macaddress mac_add} source-endpoint s-mepid
domain d-name association a-name [number num] [data string] [vlan-priority vlan-priority] [drop-
eligible { true | false }]
Syntax Definitions
t-mepid
mac_add
s-mepid
d-name
a-name
num
string
vlan-priority
true
false
Defaults
parameter
num
vlan-priority
drop-eligible {true | false}
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
OmniSwitch CLI Reference Guide
Specifies the MEP for which the Loopback message is targeted. The
valid range is 1-8191.
Target MAC address to be transmitted.
Specifies the MEP that transmits the Loopback message. The valid
range is 1–8191.
Specifies the domain name. For more information on the different
formats of the domain name, refer to
Name of the Ethernet OAM Association. Up to 48 (minus the domain
name length) characters may be used.
Number of loopback messages. Valid range is 1-10.
Specifies the amount of data to be included in the Data Type Length
Value (TLV), if the Data TLV is selected to be sent. The valid range is
1–255.
VLAN Priority. Valid Range is 0-7.
Sets the drop eligibility bit in the VLAN tag to true.
Sets the drop eligibility bit in the VLAN tag to false.
default
1
CCM priority
true
June 2012
ethoam domain.
page 45-39