Efm-Oam Port Mode - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

efm-oam port mode

Configures the LINK OAM mode on the port or on the range of ports to active or passive.
efm-oam port slot/port[-port2] mode {active | passive}
Syntax Definitions
slot/port
-port2
active
passive
Defaults
By default, LINK OAM mode is set to active on all ports.
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855.
Usage Guidelines
•
LINK OAM discovery process is never initiated from a port when it is in passive mode. At least one of
the two peer ports should be in active mode.
•
An active port will respond to Loopback-control OAMPDUs only if the peer EFM-OAM client is also
in active mode.
Examples
-> efm-oam port 1/1 mode active
-> efm-oam port 1/1 mode passive
-> efm-oam port 2/1-10 mode active
-> efm-oam port 2/1-4 mode passive
Release History
Release 6.4.2; command was introduced.
page 46-6
The slot number for the module and the physical port number on that
module (e.g. 3/1 specifies port 1 on slot 3).
Specifies the last port in the range of ports.
Configures the LINK OAM mode to active.
Configures the LINK OAM mode to passive.
LINK OAM Commands
OmniSwitch CLI Reference Guide June 2012