Show Module Status - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

show module status

Displays the basic status information for either a specified module or all modules installed in a standalone
switch chassis or a stack. Modules include switches performing the primary and secondary CMM roles
and Network Interface (NI) in a stack.
show module status [number]
Syntax Definitions
number
Defaults
N/A
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E.
Usage Guidelines
This command may be used when logged into the switch that performs either as the primary or secondary
CMM role in a stack.
Examples
-> show module status
Operational
Slot Status
------+-------------+------------+---------+-----------------
CMM-1 UP
NI-1 UP
output definitions
Slot
Operational Status
Admin-Status
page 54-46
The slot number for a specific module installed in a standalone switch
chassis or the switch number within a stack. If no slot number is speci-
fied, status information for all modules is displayed.
Firmware
Admin-Status Rev
POWER ON N/A
POWER ON N/A
The chassis slot position of the module. For detailed slot numbering
information, refer to the "Chassis and Power Supplies" chapter of the
Hardware User Guide. Refer to
on CMM callouts.
The operational status of the module. Options include UP or DOWN.
For NI and secondary CMM modules, the operational status can be
DOWN while the power status is on, indicating a possible software
issue.
The current power status of the module. Options include POWER ON
or POWER OFF.
Chassis Management and Monitoring Commands
MAC
00:d0:95:a3:e5:09
00:d0:95:a3:e5:0b
page 54-36 for additional information
OmniSwitch CLI Reference Guide June 2012