Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual page 2520

output definitions
direction
operational directions
port-control
quiet-period
tx-period
supp-timeout
server-timeout
max-req
re-authperiod
reauthentication
Supplicant polling retry count The number of times a device is polled for EAP frames to determine
Captive Portal Session Limit
(hrs)
Captive Portal Login Retry
Count
Supplicant Bypass
page 35-46
Whether the port is configured for control on bidirectional traffic or
incoming traffic only (both or in). Configured through the
mand.
The operational state of controlled direction on the port, which is set
automatically by the switch. If the value of direction is both, the value
of operational directions is both. If the value of direction is in, the
operational state is set to in on initialization and when the port's MAC
address becomes operable. If the port's MAC address becomes inopera-
ble, the operational direction is set to both.
The value of the port control parameter for the port (auto, force-autho-
rized, or force-unauthorized). Configured through the
mand.
The time during which the port will not accept an 802.1X authentica-
tion attempt; the timer is activated after any authentication failure. The
range is 0 to 65535 seconds. Configured through the
The time before an EAP Request Identity will be transmitted. The range
is 1 to 65535 seconds. Configured through the
The number of seconds before the switch will time out an 802.1x user
who is attempting to authenticate. Configured through the
mand.
The timeout for the authentication server for authentication attempts.
Configured for the switch port through the
this value is always superseded by the value configured for the
RADIUS authentication server configured through the
server command.
The maximum number of times the switch will retransmit a request for
authentication information (request identity, password, challenge, etc.)
to the 802.1X user before it times out the authentication session based
on the supp-timeout. The range is 1 to 10. Configured through the
802.1x command.
The amount of time that must expire before the switch requires re-
authentication of the Supplicant on this port. Only applicable when re-
authentication is enabled. Configured through the
Whether or not the port will be re-authenticated after the re-authperiod
expires. Configured through the
whether or not the device is an 802.1x client. Configured through the
802.1x supp-polling retry
The amount of time, in hours, that a Captive Portal session can remain
active. Configured through the
command.
The number of login attempts allowed before the Captive Portal fail
policy is applied to the device. Configured through the
portal retry-count command.
The status of 802.1x authentication bypass (enable or disable). Config-
ured through the 802.1x supplicant bypass
802.1x
802.1x command. However,
802.1x
802.1x command.
command.
802.1x captive-portal session-limit
command.
OmniSwitch CLI Reference Guide
802.1X Commands
802.1x com-
802.1x com-
802.1x command.
command.
802.1x com-
aaa radius-
command.
802.1x captive-
June 2012