port mapping unknown-unicast-flooding
Enables or disables flooding of unknown unicast traffic from all ports to user ports for a particular session.
port mapping session id unknown-unicast-flooding {enable | disable}
Synatax Definitions
session id
enable
disable
Defaults
parameter
enable | disable
Platform Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
•
Flooding of unknown unicast traffic is enabled by default.
•
Unknown unicast flooding for the user ports will be enabled if port mapping is disabled on a session.
•
Configuring unknown unicast flooding will create a new port mapping session if there is no existing
session.
•
When a link aggregate is configured as a user port, the unknown unicast flooding configuration will be
applied to all the member ports of the aggregate.
•
Enabling this command affects unicast flooding to the user ports from all the switch ports, not just the
network ports for the session.
Examples
-> portmapping 1 unknown-unicast-flooding enable
-> portmapping 2 unknown-unicast-flooding disable
Release History
Release 6.3.4; command was introduced.
page 39-8
The port mapping session for which the unknown unicast flooding status
is to be configured.
Enables the flooding of unknown unicast traffic from all ports to the
user ports for a particular session.
Disables the flooding of unknown unicast traffic from all ports to the
user ports for a particular session.
default
enable
Port Mapping Commands
OmniSwitch CLI Reference Guide
June 2012