ADTRAN AOS Version R10.1.0 Command Reference Manual page 3956

Command Reference Guide
attribute <number>
Use the attribute command to define attributes for the associated Internet key exchange (IKE) policy.
Multiple attributes can be created for a single IKE policy. Once you enter this command, you are in the
IKE Policy Attribute mode. Refer to
information. Use the no form of this command to remove a defined attribute.
Syntax Description
<number>
Default Values
By default, no attribute is defined.
Command History
Release 4.1
Functional Notes
Multiple attributes on an IKE policy are ordered by number (with the lowest number representing the
highest priority).
Usage Examples
The following example defines a policy attribute (10) and takes you into the IKE policy attributes:
(config)#crypto ike policy 1
(config-ike)#attribute 10
(config-ike-attribute)#
60000CRG0-35E
IKE Policy Attributes Command Set on page 3948
Assigns a number (range: 1 to 65535) to the attribute policy. The number is
the attribute's priority number and specifies the order in which the resulting
virtual private network (VPN) proposals get sent to the far end.
This command takes you to the (config-ike-attribute)# prompt. From here,
you can configure the settings for the attribute as outlined in the section
Policy Attributes Command Set on page
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
IKE Policy Command Set
for more
3948.
IKE
3956