ADTRAN AOS Version R10.1.0 Command Reference Manual page 3960

Command Reference Guide
client configuration pool <name>
Use the client configuration pool command to configure AOS to perform as mode-config server (edge
device) when an Internet key exchange (IKE) policy is negotiated. Use the no form of this command to
return to the default setting. Variations of this command include the following:
client configuration pool <name>
client configuration pool <name> initiate
client configuration pool <name> initiate respond
client configuration pool <name> respond
client configuration pool <name> respond initiate
Syntax Description
<name>
initiate
respond
Default Values
By default, if this command is not present in the IKE policy, the ADTRAN device allocates mode-config IP
addresses, domain naming system (DNS) server addresses, and network basic input/output system
(NetBIOS) name server addresses, and mode-config is not performed.
Command History
Release 4.1
Functional Notes
This command ties an existing client configuration pool to an IKE policy.
By using the initiate and respond commands, you can configure the IKE policy to initiate and respond,
initiate only, or respond only. It is an error if you have both initiate and respond disabled.
Usage Examples
The following example ties the ConfigPool1 configuration pool to this IKE policy:
(config)#crypto ike policy 1
(config-ike)#client configuration pool ConfigPool1
60000CRG0-35E
Specifies the pool from which to obtain parameters to assign to the client.
Enables set/ack (push) mode.
Enables request/response mode.
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
IKE Policy Command Set
3960