ADTRAN AOS Version R10.1.0 Command Reference Manual page 2531

Adtran operating system (aos)
Table of Contents

Advertisement

Command Reference Guide
ip unnumbered <interface>
Use the ip unnumbered command to use the IP address assigned to the specified interface for all IP
processing on the active interface. Use the no form of this command to remove the unnumbered
configuration.
Syntax Description
<interface>
Default Values
By default, all interfaces are configured to use a specified IP address (using the ip address command).
Command History
Release 1.1
Release 11.1
Release A4.01
Functional Notes
If ip unnumbered is enabled on an interface, all IP traffic from the interface will use a source IP address
taken from the specified interface. For example, specifying ip unnumbered eth 0/1 while in the
Point-to-Point Protocol (PPP) Interface Configuration mode configures the PPP interface to use the IP
address assigned to the Ethernet interface for all IP processing. In addition, AOS uses the specified
interface information when sending route updates over the unnumbered interface. Static routes may either
use the interface name (ppp 1) or the far-end address (if it will be discovered).
Usage Examples
The following example configures the PPP interface (labeled ppp 1) to use the IP address assigned to the
Ethernet interface (eth 0/1):
(config)#interface ppp 1
(config-ppp 1)#ip unnumbered eth 0/1
60000CRG0-35E
Specifies the interface that contains the IP address to use as the source
address for all packets transmitted on this interface. Specify an interface in
the format <interface type [slot/port | slot/port.subinterface id | interface id |
interface id.subinterface id | ap | ap/radio | ap/radio.vap]>. For example, for
a T1 interface, use t1 0/1; for an Ethernet subinterface, use eth 0/1.1; for a
PPP interface, use ppp 1; for an ATM subinterface, use atm 1.1; and for a
wireless virtual access point, use dot11ap 1/1.1. Type ip unnumbered ?
for a list of valid interfaces.
Command was introduced.
Command was expanded to include the demand interfaces.
Command was expanded to include the Metro Ethernet Forum (MEF) Metro
Ethernet interface.
Copyright © 2012 ADTRAN, Inc.
PPP Interface Command Set
2531

Advertisement

Table of Contents
loading

Related Products for ADTRAN AOS Version R10.1.0

This manual is also suitable for:

Aos r10.1.0

Table of Contents