ADTRAN AOS Version R10.1.0 Command Reference Manual page 2468

Command Reference Guide
bridge-group <number>
Use the bridge-group command to assign an interface to the specified bridge group. This command is
supported on all Ethernet interfaces, Point-to-Point Protocol (PPP) virtual interfaces, and Frame Relay
virtual subinterfaces. Use the no form of this command to remove an interface.
Syntax Description
<number>
Default Values
By default, there are no configured bridge groups.
Command History
Release 1.1
Functional Notes
A bridged network can provide excellent traffic management to reduce collisions and limit the amount of
bandwidth wasted with unnecessary transmissions when routing is not necessary. Any two interfaces can
be bridged (Ethernet to T1 bridge, Ethernet to Frame Relay subinterface, etc.).
Usage Examples
The following example assigns the PPP interface to bridge-group 1:
(config)#interface ppp 1
(config-ppp 1)#bridge-group 1
60000CRG0-35E
Specifies the bridge group (by number) to which to assign this interface.
Range is 1 to 255.
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
PPP Interface Command Set
2468