ADTRAN AOS Version R10.1.0 Command Reference Manual page 2467

Command Reference Guide
bandwidth <value>
Use the bandwidth command to provide the bandwidth value of an interface to the higher level protocols.
This value is used in cost calculations. Use the no form of this command to restore the default value.
Syntax Description
<value>
Default Values
To view the default values, use the show interfaces command.
Command History
Release 3.1
Functional Notes
The bandwidth command is an informational value that is communicated to the higher level protocols to
be used in cost calculations. This is a routing parameter only and does not affect the physical interface.
Usage Examples
The following example sets bandwidth of the Point-to-Point Protocol (PPP) interface to 10 Mbps:
(config)#interface ppp 1
(config-ppp 1)#bandwidth 10000
60000CRG0-35E
Specifies the bandwidth value in kbps. Range is 1 to 4294967295 kbps.
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
PPP Interface Command Set
2467