Remote-Name; Reset Ike Sa - H3C MSR 20-20 Command Reference Manual

2170 C 141: IKE C
HAPTER
Description
Related command:
Example

remote-name

Syntax
View
Parameter
Description
Related command:
Example

reset ike sa

Syntax
C
ONFIGURATION OMMANDS
Use the remote-address
IPSec tunnel.
Use the
undo remote-address
Note that the ip-address configured with the remote-address command must
agree with the IP address configured with the local-address command.
id-type ip, local-address.
# Configure the remote IP address as 10.0.0.1.
<Sysname> system-view
[Sysname] ike peer peer1
[Sysname-ike-peer-peer1] remote-address 10.0.0.1
remote-name name
undo remote-name
IKE peer view
name: Name of the peer gateway for IKE negotiation, a string of 1 to 32
characters.
Use the
remote-name
Use the undo remote-name
If the IKE negotiation initiator uses its gateway name for IKE negotiation (that is,
the id-type name command is configured on the initiator), it sends the name as
its identity to the peer, whereas the peer uses the gateway name configured with
the remote-name name command to authenticate the initiator. Therefore, the
local gateway name for a device must be identical to the remote gateway name
configured on its peer.
id-type, ike local-name.
# Configure the remote gateway name as apple for IKE peer peer1.
<Sysname> system-view
[Sysname] ike peer peer1
[Sysname-ike-peer-peer1] remote-name apple
reset ike sa [ connection-id ]
command to configure the remote IP address of the
command to remove the configuration.
command to configure the name of the remote gateway.
command to remove the configuration.